Does anyone have any pics and sizes of the small table that clips to the dashboard, as I would like to try and replicate one so pics of the brackets as well and how it clips to the partition would be helpful.
Thanks
Cab table
Re: Cab table
Chris, I also made two pics of the cab 'table', actually a clipboard with two clips and pen holes. Measurements 40 x 40 x 1.6 centimetres.
It doesn't clip to the bulkhead (where it is just slided-in for storage) but to the dashboard, passenger's side. The according pins are similar to the metal armrest pins in the rear compartment but in contrast to them plastic ones and likely to break.
Blurred again, I hate this ALDI camera ...
It doesn't clip to the bulkhead (where it is just slided-in for storage) but to the dashboard, passenger's side. The according pins are similar to the metal armrest pins in the rear compartment but in contrast to them plastic ones and likely to break.
Blurred again, I hate this ALDI camera ...
-
- EVW Addict
- Posts:273
- Joined:Wed Aug 12, 2009 7:04 pm
Re: Cab table
Thank you Roland,
Thats extremely helpful, and I don't want to seem rude by asking but would you be able to take the time when you have an opportunity to photograph the brackets on the dashboard for me please? Then I have some shopping for the brackets and clipboard clips, which I am sure I can find something similar, though I think finding some matching wood will be a little bit harder, so a challenge for me
I always wondered how this was stored with the wooden panel on the bulkhead, as there are not many photos of these items in the wild.
Thanks again,
Chris
Thats extremely helpful, and I don't want to seem rude by asking but would you be able to take the time when you have an opportunity to photograph the brackets on the dashboard for me please? Then I have some shopping for the brackets and clipboard clips, which I am sure I can find something similar, though I think finding some matching wood will be a little bit harder, so a challenge for me
I always wondered how this was stored with the wooden panel on the bulkhead, as there are not many photos of these items in the wild.
Thanks again,
Chris
Re: Cab table
It doesn't make much sense to photograph the dash brackets, as the result would be blurred.
Your enquiry pushed me to find out the maker anyway, one of my pins is broken, see 2nd pic above. No luck yet.
Your enquiry pushed me to find out the maker anyway, one of my pins is broken, see 2nd pic above. No luck yet.
-
- EVW Addict
- Posts:273
- Joined:Wed Aug 12, 2009 7:04 pm
Re: Cab table
Good evening Roland,
Thanks again, I will have a look through my Trigano and Movera service catalogues to see if I can find something that may be a suitable alternative as the brackets are similar to door retainers we use.
I will keep you posted.
Thanks again, I will have a look through my Trigano and Movera service catalogues to see if I can find something that may be a suitable alternative as the brackets are similar to door retainers we use.
I will keep you posted.
-
- EVW Addict
- Posts:273
- Joined:Wed Aug 12, 2009 7:04 pm
Re: Cab table
I've found the following bracket through Trigano which I think is pretty similar, ignore the price as Trigano do set retail prices high and many trade prices are low.
http://www.trigano-service.com/produit. ... od=X801025
http://www.trigano-service.com/produit. ... od=X801025
Re: Cab table
Not exactly the same but pretty similar indeed. That should do. Good find! I had no luck yet.
Especially the dash brackets look different, hard to see
Especially the dash brackets look different, hard to see